Power UNITS FOR LIFT TABLE 1
Common Description
This power unit is made exclusively for your modest lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit continues to be extensively applied in the industry of logistic units for example minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed through the solenoid valve with all the speed controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
General Description
This power unit is developed solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and the pace controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the energy supply is cut, the reducing motion is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE three
Standard Description
This energy unit is built exclusively for that big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as the pace managed by a stress compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This energy unit is intended solely for that huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve plus the speed controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the energy provide is lower, the lowering movement is controlled through the manual override function.
Particular Notes
one. This energy unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned just before set up of the energy unit.
3. Viscosity with the oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
4. Oil changing is needed after the preliminary one hundred operation hours,afterwards when each 3000 hours.
five. The energy unit proven is created to be mounted vertically.

TAGs:

Tractor Shaft

As one of the tractor shaft manufacturers, suppliers, and exporters of mechanical products, We offer tractor shafts and many other products.

Please get in touch with us for details.

Manufacturer supplier exporter of tractor shaft.