Materials Managing Electrical power UNIT 1
This electrical power unit is intended for that fork lift market, consisting of extremely productive gear pump, DC motor, guide raise and reduced valve, tank, ect. The up and down motion are controlled through the lever on the manual release valve, which can be equipped with an electrical switch to activate the motor. The lowing speed is controlled from the strain compensated flow manage valve.
1. The duty of this energy unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean all of the hydraulic parts concerned in advance of set up of the energy unit.
three. Viscosity on the hydraulic oil shoud be 15~46 cst, which must also be clean and cost-free of impurities, N46 hydraulic oil is proposed .
four. Oil modifying is required following the original a hundred operation hours, afterwards after every 3000 hrs.
5. The energy unit proven is created to be mounted horizontally.
Material Dealing with Electrical power UNIT 2
This energy unit attributes energy up gravity down circuit. Activate the start off solenoid to start the motor to lift the machine. The lowing motion is activated by the solenoid valve together with the decreasing pace managed by the pressure compensated flow manage valve. Merchandise of this series can be extensively used in the market of logistic units which include fork lift, mini lift table, etc.
1. The duty of this energy unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean each of the hydraulic components concerned before mounting the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which need to also be clean and totally free of impurities, N46 hydraulic oil is advised .
4. Oil altering is required just after the initial 100 operation hrs,afterwards once every 3000 hours.
5. The energy unit ought to be mounted horizontally.